The Sit Means Sit Collar – Change ID Codes
CHANGE ID CODES
An ID Code is the signal identification between the Remote Transmitter and Collar Receiver. Each is
programmed in 1 of 2,000 ID Codes from the factory. The SD-825SMS has the flexibility to program two
or more Remote Transmitters to the same IDCode, allowing them to control one Collar Receiver. There
are 64 programmable ID Codes available.
TO MANUALLY PROGRAM A REMOTE TRANSMITTER’S ID CODE FOLLOW THESE STEPS:
1. Turn the Intensity Dial to V/T, and then press and release the Mode Button on the back of your
Remote Transmitter. This does not change the mode, so the current mode will still be active
after the ID change is complete.
2. Once the Mode Button is released, the Transmitter Indicator Light will illuminate solid green and
stay on for 15 seconds.
3. While the green Indicator Light is on, turn the Intensity Dial to select the 1st digit of the ID and then
press and release the Side Button. The green Indicator Light will flash rapidly confirming selection.
4. Again,while the green Indicator Light is on, turn the IntensityDial to select the 2nd digit of the IDand then
press and release the Side Button. The green Indicator Light will flash rapidly confirming selection. The
2nd digit is optional and, if not desired, wait until the green light turns off and refrain from pressing
the Side Button.
5. At the end of 15 seconds, or after the second press of the Side Button, the green Indicator Light will turn off
and the ID of the unit will be updated. At this point, the unit will be in the same mode it was in prior
to setting the ID.
6. Upon changing the ID Code, you will need to match the Collar Receiver to the Remote Transmitter
(see STEP 6 on page 14).
To return the unit to the factory ID follow these steps:
1. Turn the Intensity Dial to V/T, and then press and release the Mode Button on the back of your
Remote Transmitter. This does not change the mode, so the current mode will still be active after
the ID change is complete.
2. Do not press any buttons and wait until the green Transmitter Indicator Light turns off.
3. You will need to match the Collar Receiver to the Remote Transmitter