Resources

Programming instructions for your Sit Means Sit Collar.   Connect a new or replacement remote transmitter or collar receiver? – click here Do you need to pair or sync the handheld remote with a collar receiver? Adjust the stimulation range on your collar receiver to better suit your dog?  click here Did you get a…

CHANGE ID CODES An ID Code is the signal identification between the Remote Transmitter and Collar Receiver. Each is programmed in 1 of 2,000 ID Codes from the factory. The SD-825SMS has the flexibility to program two or more Remote Transmitters to the same IDCode, allowing them to control one Collar Receiver. There are 64…

MATCH THE COLLAR RECEIVER AND REMOTE TRANSMITTER To match the Collar Receiver to work with a new Remote Transmitter or to match a new Collar Receiver to work with your existing Remote Transmitter: A. Turn the Collar Receiver off. B. Press and hold the On/Off Button. The ReceiverIndicator Light will come on, then turn off…

Program the SYSTEM for Two or Three-Dog Operation Sit Means Sit Add-A-Dog® Collar Receiver(s) must be purchased to train additional dogs. 1. Program the Remote Transmitter to mode 2, 3, or 4 2. Program the first Collar Receiver. A. Turn the Collar Receiver off. B. Press and hold the On/Off Button. The Receiver Indicator Light…

The SD-825SMS Remote Transmitter has seven operational modes to allow you to select the best match for your type or style of training. The Remote Transmitter is factory set to mode 1. There is also one programming mode: Mode V/T (Change ID Codes) on page 14. TO CHANGE THE MODE: 1. Referring to the following…

CHANGING STIMULATION RANGES The SD-825SMS Collar Receiver comes with 3 stimulation ranges (low, medium, and high). There are 7 stimulation levels within each range, with 1 being the lowest and 7 being the highest. The default range setting is 1 (low). To change the range of stimulation, follow these steps: 1. Make sure the Collar…