The Sit Means Sit Collar – Program The System For Two Or Three-Dog Operation

Program the SYSTEM for Two or Three-Dog Operation
Sit Means Sit Add-A-Dog® Collar Receiver(s) must be purchased to train additional dogs.

1. Program the Remote Transmitter to mode 2, 3, or 4
2. Program the first Collar Receiver.
A. Turn the Collar Receiver off.
B. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off
after 4-5 seconds. If the On/Off Button is released too early, the Receiver Indicator Light will
begin its normal flashing. If this occurs, start over from A.
C. After the Receiver Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light
flashes 5 times. If the Receiver Indicator Light does not flash 5 times, start over from A.
3. Program the second Collar Receiver using A through D above, but using the Lower Button in
place of the Upper Button.
4. Program the third Collar Receiver using A through D above, but using the Side Button in place of
the Upper Button.